GATE TITAN V2 BASIC module with mosfet board for ver.II electric rifle (front wiring)

New professional programmable switch device with hi performance circuit board
fully wired device to install inside the gearbox instead of the original electric contact
the new circuit will cut the current flow sent to the internal switch to a small signal current (switch have longer life)
then the electronic unit will encrease the peak and the current drain to the main motor for max performance 
then the board held the current drain directly bypassing the trigger switch
this give the stable current drain to the aeg without electricity drop
the most benefit are those long battery last and rate of fire enhancement
the unit is available and easy install on Marui M4, aeg rifle and compatible

POWER FUNCTIONS
- trigger response enhancing
thanks to the internal sensor, user can adjust the trigger rensponse depending game,gun or magazine necessity

-motor active braking and cycle control
the internal sensor can detect the shot cycle avoiding double shooting troubles
even with extreme hi speed guns or by fast single shooting usage

- Low LIFE/LIPO indication and battery protection
the device will spin the motor with short straps to advise low battery voltage is reached...
once the over-discharge rate is near the system will not drain the current anymore to avoid battery damage

-hi voltage LIPO ready
the device is designed to resist to max 14.8V LIPO battery, and can work from 3V to 17V, depending the power and the quality of the gun

FIRE MODES
-Semi - Auto
- Semi - Burst
- AUG mode (semi / full can be choosen by triggel pull)

included parts:
-electronic unit board
-quality wires with front dean T connector (mini tamya plug included)
-instructions